June 25, 2024

Simulations of craters reveal characteristics of impactors such as spin speed, bond strength
(a) Craters on Earth’s moon (in the middle, with a smaller bow-shaped crater inside, is Poinsot crater). (b) Craters on Vesta, with a recent 20-km-diameter crater at the top of the image. (c) Layout of the numerical setup. (d) The 445-km-diameter crater on Saturn’s moon Tethys. (e) The 76-mm-diameter crater obtained numerically from the impact of a 25-mm-diameter steel sphere falling from 50 mm onto a bed of particles (glass spheres with a mean diameter of 1 mm). (f) Topography (elevation) of a crater formed by a spinning projectile consisting of bonded grains. Credit: Physical Review E (2023). DOI: 10.1103/PhysRevE.108.054904

A team of engineers at the University of Campinas, in Brazil has found that the unique characteristics of craters, both on Earth and on other bodies in space, are due to the unique features of both the impactor and the site where it strikes. In their study, reported in the journal Physical Review E, the group built and ran simulations of impactors striking planets, moons and other bodies.

Prior research has shown that have widely varying characteristics—some are deep, for example, while others are shallow. Also, some have relatively small debris fields while others cover large areas around a crater—and some have clearly defined, elevated rims, while others have no rim at all.

Theories abound regarding the reason for such differences, but as the team on this new effort found, little has been done to test them. So the team built and ran a simulation that took a host of factors into consideration that could apply when smaller space bodies crash into bodies that are much larger.

To create their simulations, the research team assembled virtual projectiles roughly the size of grapefruit—each was made up of thousands of tiny spheres to vary the degree of density. They also modeled targets using a similar approach. They then applied physics to simulate impacts—denser impactors moving very fast, for example, would hit harder than less dense, slow-moving targets.

They added other characteristics of impacts, such as how fast an impactor was moving, how fast it was spinning and its axis of spin. They also allowed for adjusting the angle of impact as desired. They ran their under a variety of circumstances to test as many factors as possible.

They noted some trends. Projectiles that shattered on impact, for example, that were spinning faster, were more likely to spread their debris farther than those spinning more slowly. They also found that crater shape was at least partly dependent on the bond strength of the material making up the impactor. They noted also that bond strength plays a role in determining whether material from the impactor makes it into the rim of a .

The researchers say their model could be used by others studying specific craters to learn more about how their features might have come about.

More information:
Douglas D. Carvalho et al, Impact craters formed by spinning granular projectiles, Physical Review E (2023). DOI: 10.1103/PhysRevE.108.054904. On arXiv: DOI: 10.48550/arxiv.2311.15026

© 2023 Science X Network

Simulations of craters reveal characteristics of impactors such as spin speed, bond strength (2023, December 14)
retrieved 14 December 2023
from https://phys.org/news/2023-12-simulations-craters-reveal-characteristics-impactors.html

This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no
part may be reproduced without the written permission. The content is provided for information purposes only.

Source link

Leave a Reply

Your email address will not be published. Required fields are marked *